|
|
TM 746-10
5-28. Gangplanks
5-27. Miscellaneous Marine Equipment
a. Coat exposed, unpainted, metal surfaces of
ropes from their installed location.
drums, barrel capstan assemblies, ratchets, hanger
assemblies, hoist bases, winch drums, anchors, end bar
b. Coat exposed, unpainted, ferrous metal
assemblies, boom pawls, circle segments, ramp angles,
surfaces with P-1 and wrap with greaseproof paper.
pneumatic wheels, boat cradles, and masts with P-1.
c. Individually pack canvas and ropes by method
III, using single-, double-, or triple-wall, water-resistant
cradles, and wheels (pneumatic) loose or secured to a
fiberboard boxes. Seal box with tape (fig 5-1).
skid-type base for ease in handling.
d. Bundle disassembled components of similar
description with metallic strapping.
e. Secure packed canvas, rope, and bundled
components to the gangplank with metallic strapping.
Section V. FSG 22, RAILWAY EQUIPMENT
5-29. Shaft Assemblies
c. Cover openings that may permit direct entry of
water with tape.
Preserve and pack shaft assemblies per paragraph 5-16
or 5-17, as applicable.
5-33. Couplers, Frames, Intercooler Compressors,
Winches, and Duplex Brake Cylinders
5-30. Valves
a. Coat exposed machined surfaces with P-10,
Preserve and pack valves per paragraph 5-11, as
wrap or cover with greaseproof barrier material, and
applicable.
secure in place with tape.
b. Coat other exposed, unpainted, ferrous metal
5-31. Miscellaneous Railway Equipment (70 Pounds
surfaces with P-1.
or Less)
c. Cover openings that may permit direct entry of
water with tape.
a. Coat exposed, machined, metal surfaces of
compressor intercoolers, piston assemblies, adjuster
5-34. Wheel Sets, Wheels, and Axles
governors, and damper assemblies with P-10. Wrap
Coat exposed machined surfaces with P-1. Although
preserved areas with greaseproof barrier material and
packing is not required, items may be skidded to provide
secure in place with tape.
a means of handling.
b. Coat interior surfaces of hydraulic-type items
with operating fluid.
5-35. Transmission and Gear Box Assemblies
material and individually pack in weatherresistant
Preserve and pack assemblies per paragraph 5-18.
fiberboard boxes. Close and seal box with tape (fig 5-
5-36. Compressors
5-32.
Armatures, Traction Motors, Generators,
Preserve and pack compressors per paragraphs 3-3 and
Exciters, and Exhausters (Vacuum)
a. Coat exterior machined surfaces with P-10,
5-37. Cabs
wrap with greaseproof barrier material, and secure in
place with tape.
a. Coat unpainted metal surfaces with P-1.
b. Coat interior metallic surfaces, as required, with
b. Coat rubber seals around doors with powdered
P-10.
talc.
material and secure in place with tape.
5-7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |