HEAD, CYLINDER

TM 55-1930-208-24

3-38. HEAD, CYLINDER

This task covers:

a. Removal

Installation

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanic's (Item 1, Appendix B)

Wrench, Torque (Item 71, Appendix B)

Materials Required:

Adhesive (Item 1, Appendix C)

Compound, Sealing (Item 22, Appendix C)

Gasket P/N 5103659

Gasket P/N 519973

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

Coolant drained (paragraph 2-17, TM 55-1930-208-10)

Exhaust manifold removed (paragraph 3-33).

Air cleaners removed (paragraph 3-18).

Inlet housing removed (paragraph 3-18).

Thermostat and housing removed (paragraph 3-28).

Water manifold removed (paragraph 3-27).

Rocker cover removed (paragraph 3-31).

Fuel injectors and fuel piping removed (paragraph 3-35).

Fuel lines removed (paragraph 3-35).

Fuel strainer removed (paragraph 3-21).

Fuel filter removed (paragraph 3-8).

Fuel injector control rack removed (paragraph 3-22).

a. Removal. (Refer to figure 3-77).

(1) Remove four lower bolts (1) and four lockwashers (2) from lifting brackets.

(2) Remove two nuts (3) and ten bolts (4).

(3) Attach a sling to the cylinder head lifting bracket and a chain hoist, lift cylinder head (5) away from the

engine.

(4) Remove and discard gasket (6) and seal rings (7).

3-134