Chapter 2. UNIT MAINTENANCE INSTRUCTIONS

TM 55-1905-223-24-7

CHAPTER 2

UNIT MAINTENANCE INSTRUCTIONS

Page

Repair Parts, Special Tools; Test, Measurement, and

Diagnostic Equipment (TMDE); and Support Equipment .........................................

Service Upon Receipt ...............................................................................................

Unit Preventive Maintenance Checks and Services (PMCS) ...................................

Unit Troubleshooting .................................................................................................

Unit Maintenance Procedures ...................................................................................

Preparation for Storage or Shipment .........................................................................

SECTION I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,

AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

2-1.

Common Tools and Equipment. For authorized common tools and equipment refer to the Modified Table of

Organization and Equipment (MTOE) applicable to your organization.

2-2.

Special Tools, TMDE, and Support Equipment. Special tools; test, measurement, and diagnostic equipment;

and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-

1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this manual.

2-3.

Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-

1905-223-24P.

SECTION II. SERVICE UPON RECEIPT

2-4.

Checking Unpacked Equipment.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the

damage in accordance with the instructions of DA Pam 738-750.

b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in

accordance with the instructions of DA Pam 738-750.

c. Check to see whether the equipment has been modified.

d. Remove protective caps, plugs, inserts, wrappings and tape when inspection/inventory is completed. Inspect

piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.

2-1