Detachment from Shelter

(a) Align spades on mobilizer with shelter brackets.

(b) Insert mobilizer spades into sockets, align

locking pin holes.

this procedure at all four attachment points on

the shelter.

(d) Pump each dolly to raised position.

(e) Lock strut in position.

(f) Install tie cable assemblies, connecting front

tighten nuts using pump

handle.

4.3.6

Detachment from Shelter

To detach shelter, proceed as follows:

(a)

Set parking brake on rear dolly.

(b)

Remove tie cable assemblies.

(c)

Lower mobilizer (refer to para 4.3.2)

(d)

Detach locking pin assembly from mounting

points.

(e) Release parking brake.

(f) Push front and rear dollies down and away

from shelter to separate.

4.3.7

Attachment to Prime Mover

To attach mobilizer to prime mover, proceed as follows:

Attach drawbar to prime mover by placing lunette

(a)

eye of mobilizer in pintle hook of prime mover.

Lock pintle hook.

(b)

Connect electrical cable assembly from rear dolly

(c)

to prime mover.(Part No. 7400017-502 only)

(d)

Connect intervehicular air line between front and

rear dollies. (part No. 7400017-502 only)

Connect air line from front dolly to prime mover.

(e)

Make certain that air line is connected to service

(f)

line, not to emergency line of prime mover(Part No. 7400017-502 only)

(g)

Check brakes for proper operation before towing

mobilizer.

NOTE

Direct excess cable over top of payload,

allow same amount of slack in line at

both front and rear.

Check brakes are released before towing mobilizer.

4.3.8

Safety Precautions

The following safety precautions must be observed to avoid

accidents and injury to personnel:

(a) Set parking brake whenever mobilizer is not being

However, if mobilizer is being parked for a

towed.

prolonged period, chock wheels securely to prevent

movement and release hand brake.

This will prevent

brake freezing due to moisture and corrosion within