Lowering Mobilizer

Lowering Mobilizer

4.3.2

Before lowering Mobilizer, place control valve in "PUMP"

position and pump up to relieve tension on struts. Release

struts by loosening wing nut. With no load on transporter,

place control valve in maximum "RELEASE" position, with pay-

load attached to Mobilizer move control valve slowly to

"RELEASE" position which allows release of pressure. Control

speed of operation by adjusting control valve.

WARNING

With control valve in fully opened position heavy loads

will be dropped abruptly, causing possible damage to

equipment and injury to personnel.

Uncoupling Front and Rear Dollies

4.3.3

To uncouple front and rear dollies proceed as follows:

(a) Remove flexible air line (Part No. 7400017-502 only)

(b) Remove pump handle from storage position

and insert in pump lever.

(d) Remove Fore and Aft lock pins.

(e) Dollies may now be moved separately.

(f) Store pump handle on dolly in position provided.

(g) Store flexible air hose. (Part No. 7400017-502 only)

4.3.4

To couple front and rear trailer dollies, proceed as follows:

(a)

Position front and rear trailer dollies back

to back and set parking brakes on front

trailer dolly.

Place forks of rear dolly on top of forks of

(b)

front dolly.

Align lock in pin holes, insert lock pin in four

(c)

(4) places.

CAUTI0N

Operator will insure that both Fore and

Aft locking pins are installed and secure.

Non-Compliance may result in serious

damage to equipment.

(d)

Raise Mobilizer (refer to para 4.3.1)

(e)

Store pump handle on doll assembly.

(f)

Attach flexible air hose.(Part No. 7000417-502).

4.3.5

Attachment to Shelter

Position rear trailer dolly at door end of the shelter and

front trailer dolly at other end of shelter, then proceed

as follows: