 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9- 2990- 205- 34&P
-
-
-
ASSEMBLY AND OPERATIONAL TESTING - CONTINUED
-
0012 00
d. Install shield (8).
NOTE
If your turbo is to be used on engine models AVDS--1790--2DR the shield is not used.
e. Install three new locking plates (9) and six cap screws (10). Do not install locking plate and two cap screws
under oil drain tube boss (11).
f.
Torque cap screws to 230 to 250 lb--in (25.99 to 28.25 NSm).
g. Install new locking plate and two cap screws under drain tube boss. Torque cap screws to 200 to 220 lb--in
(22.6 to 24.86 NSm) using box wrench (12).
NOTE
The added length of the box wrench decreases the 240 lb--in value by approximately 30 lb--in.
h. Bend locking plate tabs against flats on cap screws.
i.
Check end play (WP 0005 00--2). Total end play must be greater than 0.004 inch and less than 0.006 inch. If
end play is not within these limits, disassemble turbo and recheck for worn parts. Reassemble turbo and
recheck end play.
8
9
10
12
11
03i498m
0012 00- 11
-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals