 |
|||
|
|
|||
|
Page Title:
Section III. CLEANING, INSPECTION, AND REPAIR |
|
||
| ||||||||||
|
|
 Section III. CLEANING, INSPECTION, AND REPAIR
24. GENERAL
b . Field Coils. Clean field coils and frame
thoroughly with a cloth dampened with dry clean-
This section contains instructions for clean-
ing solvent. Be careful not to damage protective
i n g , inspection, and repair or replacement of
insulation coating. Dry thoroughly with com-
the parts of the starter. The following general
pressed air.
procedures should be followed, where applicable.
c . A r m a t u r e . Remove loose particles from
a. Inspect all bolts, screws, nuts, and plugs
armature with compressed air and wipe with a
for worn or damaged threads. Discard and re-
clean cloth dampened with dry cleaning solvent.
place all defective parts.
Clean commutator lightly with No. 00 sandpaper
and remove all traces of dust with low-pressure
c o m p r e s s e d air.
b . Discard and replace all preformed pack-
ings, gaskets, and oil seals. Appendix II, Repair
d . B r u s h H o l d e r Assembly. Clean brush
Parts, lists a gasket and preformed packing set
holders, springs, and screws with a brush and
for the starter.
dry cleaning solvent and dry them thoroughly
with compressed air. Clean insulation and plates
25. CLEANING
with a clean cloth dampened with dry cleaning
solvent and dry with compressed air.
a . General. Special cleaning instructions for
e l e c t r i c a l parts are detailed below. Clean all
other parts in dry cleaning solvent or mineral
cloth dampened with dry cleaning solvent and dry
spirits paint thinner and dry with compressed
with low-pressure compressed air.
air.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals