Drive End Housing Assembly.

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

ASSEMBLY OF THE STARTER - CONTINUED

0010 00

9. Drive End Housing Assembly.

a. Apply a light coat of grease to gasket (1). Install new gasket (1) in counterbore at outer end of lever housing

(2).

b. Install red rubber seal plug (3) into counterbored tapped hole of lever housing (2). Hole is almost in front of

lever pivot (4).

Apply a light coat of grease to inner surface of bushing (5) in end housing (6). Bring drive end housing (6) into

position over drive clutch assembly (7) and align scribe marks (8) made during disassembly.

d. Install short socket head bolt (9) through mounting flange of drive end housing (6) and into lever housing (2)

at position shown.

e. Install five long socket head bolts (10) at all other attach points for lever housing (2).

Torque six socket head bolts to 13--17 lb--ft (17.6 to 23.0 Nm).

g. Install rubber ball seal plug (3) in each of six unused holes.

h. Install new lubricated wick (11) and oil reservoir cap (12) into drive end housing (6). Using wood block and

hammer, tap in cap flush with housing.

0010 00- 15