Brush Holder Assembly.

TM 9- 2920- 232- 34&P / TO 38X14- 2- 32

- -

ASSEMBLY OF THE STARTER - CONTINUED

0010 00

Position solenoid assembly (2) on frame assembly (12) so that MTR terminal stud (13) engages hole in

bracket (14).

g. Apply sealing compound to threads of four bolts (15) and install to attach solenoid assembly (2) to starter

frame assembly (12). Torque bolts to 95--125 lb--in (10.7 to 14.1 Nm).

h. Install washer nut (16) on MTR terminal stud (13) of solenoid assembly (2) to secure bracket (14) to terminal.

Torque washer nut (16) and washer nut (17), which secures other end of the bracket to field coil terminal to

20--25 lb--ft (27 to 34 Nm).

4. Brush Holder Assembly.

a. Install a new brush spring (1) in brush holder (2), using brush spring wind tool (3) as follows:

1) Back out brush holder attaching screw (4) which is in line with spring (I) and loosen pivot screw (6).

2) Pivot brush holder (2) inward about 30 degrees for tool clearance and tighten pivot screw (6) to hold in

position.

3) Put spring (1) in spring wind tool (3) and hook center of spring in holder (2).

4) Rotate lifter clockwise to wind spring (1) and push spring up into holder (2).

5) Pivot holder (2) back into normal position and torque attaching screws (4) with 18--24 lb--in (2.0 to 2.7

Nm).

0010 00- 6