Fan and Adapter Generator (10889713).

TM 9- 2920- 224- 34&P

ASSEMBLY OF THE GENERATOR - CONTINUED

0010 00

11. Fan and Adapter Generator (10889713).

CAUTION

Avoid getting sealant in or over mounting holes in adapter

surface.

a. On generator (10889713), apply a 1/16 inch thick coat of sealant to mounting surface of adapter (1). Perform

step b before sealant sets.

NOTE

Reference marks made during disassembly will be aligned when fan adapter is properly

positioned on support assembly.

Bring mounting surfaces together while sealant is still wet.

b. Install flat washer (2) on each of 12 machine screws (3), and put screws through mounting holes in adapter

(1). Position adapter with installed fan (4), aligned with support assembly (5) and close enough for all screws

(3) to be started in tapped holes of stator housing (6).

Torque machine screws (3) to 37--42 Ib--in (4.2 to 4.7 Nm) alternately and evenly.

d. Wipe excess sealant from around adapter (1) and support assembly (5) junction.

e. Use six 12--inch pieces of nonelectrical wire (7) to tie screws (3) in pairs.

0010 00- 21