Rotate support assembly

TM 9- 2920- 224- 34&P

ASSEMBLY OF THE GENERATOR - CONTINUED

0010 00

NOTE

Use of machine screws prevents bleed of sealant into

tapped holes.

Rotate support assembly (3) as necessary to align marks (5) made during disassembly. For generators with

wet sealant (step b) temporarily start machine screws (6) which will later attach air intake to stator assembly

(1). Ensure bearing (7) at drive end of generator is aligned with bearing bore in housing (1), and move support

assembly (3) into place against housing. Tap on support assembly and/or end of armature shaft (8) with a

soft--faced mallet to bottom support assembly in stator assembly (1).

d. Wipe excess sealant from around housing (1) at housing--support assembly junction.

e. After sealant has set, remove machine screws (6).

0010 00- 17