Stator Assembly.

TM 9- 2920- 224- 34&P

ASSEMBLY OF THE GENERATOR - CONTINUED

0010 00

NOTE

If slippage of damper mechanism cannot be set within

proper range or if single mark does not return to near

center of double marks, part(s) of generator drive shaft

are distorted or excessively worn. Defective part(s) must

be replaced and slip torque adjusted.

When damper mechanism (13) is properly adjusted, remove generator drive shaft (2) from armature (7).

1) Remove armature (7) with installed parts from vise.

7. Stator Assembly.

a. Ensure all terminal--ended field leads in stator assembly (1) are positioned to clear armature poles (2). Slide

armature with installed parts carefully into stator assembly until a gap of about one inch remains between

flange of support assembly (3) and mounting surface (4) of stator assembly housing.

CAUTION

Use care to avoid getting sealant into or over tapped

holes in this surface. Do not allow sealant to set before

performing step c.

NOTE

Generator 8717421 does not require waterproofing

sealant.

b. Generator 10889713 or 11642898, requires a coating of sealant about 1/16 inch thick to mounting surface (4)

of stator housing.

0010 00- 16