Installation of Governor.

TM 9-2910-226-34

3-43. Installation of Governor.

a. Assembly. The governor was partially

assembled during repair (para 3-25). The remainder

of governor assembly is accomplished with the

governor housing installed on the fuel injection

pump housing.

b. Install Governor and Associated Parts. Refer

to figure 3-140. Coat both sides of governor housing

gasket with a suitable sealer MIL-S-45180. Install

governor housing gasket (A). Guide fuel control rod

through timing window and install governor (B) on

injection pump housing with sliding sleeve engaging

weight and spider assembly. Install two machine

screws (C) and lockwashers (D). Install three

machine screws (F) and lockwashers (G). Torque

tighten screws to 50-80 inch-pounds and secure with

locking wire (H). Lock wire bottom screw to quill

shaft cover attaching screws. See figure 3-141.

Figure 3-141. Securing quill shaft cover screws and bottom

governor attaching screw.

c. Install Governor Springs.

NOTE

In order to select proper governor inner and

outer spacers, the idle screw must be backed

out flush with the bottom of the operating

bearing flange, allowing the governor sliding

sleeve to move inward to the extreme point

of travel. Operating lever must be in idle

position as shown in figure 3-140.

(1) Position operating lever so stop is in contact

with low idle screw flange. Refer to figure 3-142 and

3-143 for selection of governor outer and inner

springs.

Figure 3-140. Installing governor on injection pump housing.

3-82