Repair of Governor Assembly

TM 9-2910-226-34

Figure 3-53. Modification of fuel density compensator fuel

control link.

of Governor Assembly. a .

3-25. Repair

Disassembly. Disassemble the governor assembly as

follows:

(1) Refer to figure 3-54. Cut locking wire (A) and

remove two capscrews (B) and lockwashers (C).

Remove governor end cap (D). Remove and discard

cap gasket (E).

Figure 3-52. Inspecting fuel density compensator brass plug

for leakage.

(5) Check compensator for fuel leakage around

the piston shaft and at the brass plug under the stop

plate guide (fig. 4-52). A trace of fuel iS permissible)

but if a drop forms, replace the compensator.

(6) If compensator operation meets this test, no

further inspection is necessary.

(7) If compensator operation does not meet this

test, replace with a new unit.

c. If compensator 2910-907-0665 is equipped with

an undrilled link and a push nut in place of drilled

link (A), washer (B) and pin (C) fig. 3-53, discard nut

and modify link as shown in figure 3-53, by drilling a

hole and using the desired washer and pin.

Figure 3-54. Removing governor end cap.

3-38