Removal of Governor Weight and Spider Assembly

TM 9-2910-226-34

and turn puller screw slowly until the weight and

spider assembly is removed from the camshaft.

Figure 3-14. Removing governor weight and spider assembly

using puller 5120-793-5048 and remover and

replacer 5120-793-5055.

Figure 3-13. Removing governor assembly.

3-12. Removal of Timing Device Assembly. a. Refer

to figure 3-15. Disconnect and remove oil hose

3-11. Removal of Governor Weight and Spider

assembly (A), pipe-to-tube tee (B), pipe-to-tube

Assembly. Refer to figure 3-14. Position remover

elbow (C) and hex nipple (D). Remove two capscrews

and replacer against the camshaft shoulder. If the

remover and replacer does not clear the governor

(E), Iockwashers (F) and flat washers (G). Remove

timing device assembly (H). Remove and discard

weight fingers, rotate the friction drive spider while

preformed packing (J).

keeping the camshaft stationary. Install the puller,

Figure 3-15. Removing timing device assembly.

3-6