 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR TEST (Sheet 2 of 5)
4.
CHECK RESISTANCE BETWEEN TWO
BRUSH SET TERMINALS BY PUTTING
RED PROBE ON BRUSH SPRING HOLDER
(1) AND BLACK PROBE ON BRUSH
LOCKING PLATE SCREW (2), WITH
MULTIMETER SET AT RX1 OHMS.
RESISTANCE SHOULD BE LESS THAN 10
OHMS. IF RESISTANCE IS 10 OHMS OR
MORE, SKIP STEPS 5 AND 6.
5.
REPEAT STEP 4 FOR ALL BRUSH SETS.
6.
CHECK RESISTANCE BETWEEN EACH
HOLDER (1) AND END HOUSING (3)
WITH MULTIMETER SET AT RX10,000
OHMS. IF MULTIMETER READS
ANYTHING EXCEPT INFINITY,
DO STEP 7.
POSITION COVER (4) AND NEW GASKET
7.
(5) IN PLACE OVER FOUR FIELD RING
ASSEMBLY WINDOWS (6) WITHOUT
DISTURBING WIRE (7). INSTALL FOUR
NUTS (81 TO TWO T-SCREWS (9).
REPLACE STARTER MOTOR (10).
Go on to Sheet 3
9-44
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals