 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
STARTER MOTOR REPAIR (Sheet 3 of 12)
5.
SCRIBE A STRAIGHT LINE (1) ACROSS
DRIVE HOUSING (2) AND LEVER
HOUSING (3) AT PIPE PLUG (4).
6.
REMOVE SIX SCREWS (5). TAP HOUSING
(2) FROM HOUSING (3). REMOVE GASKET
(6).
REMOVE HOUSING (3). PREFORMED
7.
PACKING (7), OUTER THRUST BEARING
RACE (8), NEEDLE BEARING (9), INNER
BEARING RACE (10), AND WASHER (11).
a. Tap out valve to shaft pin (12) from
housing collar (13). Pull off collar (13).
b. Remove five screws (14) and lockwashers
(15) from housing (3). Loosen clamp (16).
NOTE
Clutch motor drive (17) may fall out of housing (3)
w h e n housing (3) is removed from winding
frame 18).
c. Pry housing (2) from frame (18) and
switch (19).
d. Remove packing (7) from housing (3).
e. Remove outer race (8), bearing (9), inner
race (10), and washer (11) from armature
shaft (20).
8. INSPECT PARTS FOR DAMAGE. REPLACE
AS REQUIRED.
9. REMOVE STARTER MOTOR ARMATURE
(21) AND WASHER (22) FROM
FRAME (18).
REPAIR:
NOTE
If starter motor is found to be damaged, assemble
starter motor (page 9-37) and replace.
Go on to Sheet 4
9-30
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals