CLEAN ARMATURE - TM-9-2835-255-340725

TM 9-2835-255-34

STARTER MOTOR REPAIR (Sheet 6 of 13)

WARNING

Compressed air used for cleaning purposes will not exceed 30 psi. Use only with

effective chip guarding and personal protective equipment (goggles/faceshield,

gloves, etc.).

9. CLEAN ARMATURE (1) AND CHECK

DIAMETER OF COMMUTATOR (2).

a. Blow off loose copper and mica particles

from commutator (2) with IOW pressure

air.

b. Turn lathe on. Polish commutator (2)

with sandpaper. Turn lathe off.

c. Check diameter of commutator (2) to

commutator (2) is not within limits,

assemble starter motor (page 9-16) and

replace.

10. INSPECT SPACER WASHER (3) FOR

DAMAGE. REPLACE AS REQUIRED.

11 INSPECT HOUSING (4) AND BOOT (5)

FOR DAMAGE. PUSH AND PULL

CLUTCH MOTOR DRIVE (6) AND LOOK

FOR MOVEMENT OF PLUNGER (7). IF

PLUNGER (7) DOES NOT MOVE OR ANY

PART IS DAMAGED, DO STEPS 12

THRU 20.

Go on to Sheet 7

9-11