INSTALLATION - TM-9-2835-255-340707

TM 9-2835-255-34

REDUCTION GEARBOX LUBRICATION SYSTEM CLEANING (Sheet 3 of 3)

3. REMOVE PORT COVER (1) AND

PREFORMED PACKING (2). CLEAN OIL

TANK (3).

a. Remove four screws (4) and lockwashers

(5). Remove cover (1) and packing (2).

b. Rinse inside of oil tank (3) with solvent

and wipe clean. Use rag.

4. INSPECT PARTS FOR DAMAGE. REPLACE

AS REQUIRED.

INSTALLATION:

1. INSTALL COVER (1) AND NEW

PACKING (2).

a. Install packing (2) on cover (1). Install

cover (1) on oil tank (3).

b. Install four screws (4) and new

2. INSTALL FLUID FILTER ELEMENT (ENGINE OIL PUMP TO OIL COOLER) (TM 20-1).

3. INSTALL OIL TANK FILTER ASSEMBLY (TM 20-1).

4. INSTALL TUBE ASSEMBLY (REDUCTION GEARBOX FEED) (PAGE 6-7).

5. INSTALL TUBE ASSEMBLY (REDUCTION GEARBOX OIL FEED - FORWARD) (TM 20-1).

6. INSTALL TUBE ASSEMBLY (REDUCTION GEARBOX OIL FEED) (TM 20-1).

7. INSTALL TUBE ASSEMBLY (REDUCTION GEARBOX SCAVENGE - REAR) (PAGE 6-9).

8. INSTALL TUBE ASSEMBLIES (FORWARD REDUCTION GEARBOX SCAVENGE) (TM 20-1).

9. INSTALL TUBE ASSEMBLY (OIL PUMP RETURN TO COOLER - FORWARD) (TM 20-1).

10. INSTALL TUBE ASSEMBLIES (OIL TANK TO ENGINE OIL PUMP) (TM 20-1).

11. INSTALL GENERATOR OIL OUTLET HOSE (TM 20-1).

12. INSTALL GENERATOR OIL INLET HOSE (TM 20-1).

13. INSTALL COOLER INLET AND OUTLET TUBE ASSEMBLY (RIGHT SIDE) (TM 20-1).

14. INSTALL COOLER INLET OR OUTLET TUBE ASSEMBLY (CROSSOVER) (TM 20-1).

15. INSTALL COOLER INLET OR OUTLET TUBE ASSEMBLY (LEFT SIDE) (TM 20-1).

16. FILL OIL TANK (LO -12).

End of Task

8-3