INSTALL NEW DIRECT LINEAR VALVE

TM 9-2835-255-34

LINEAR VALVE REPLACEMENT (Sheet 4 of 6)

(1) INTO ELECTROMECHANICAL FUEL

SYSTEM (2).

NOTE

Do not install screws and washers in direct linear

valve at this time.

ATTACH NON-ELECTRICAL WIRE (3) TO

PINS (4) AND ROUTE THROUGH ELEC-

TROMECHANICAL FUEL SYSTEM (2).

At access cavity (5), attach non- electrical

wire (3) to pins (4) with knot. Cover with

tape to form smooth .surface.

b. Route linear valve wires carefully out

through connector elbow (6).

Remove tape and non-electrical wire from

pins,

INSTALL PINS AND WIRES (7,8) IN CON-

NECTOR (9).

a. Using pin extractor and installation tool,

install wire and pin (7) (red) into C and

wire and pin (8) (blue) into D in

connector (9).

Go on to Sheet 5

Change 4 7-43