 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2635-255-34
ACCESSORY SEAL ASSEMBLY REPLACEMENT (Sheet 6 of 7)
3.
INSTALL NEW SEAL (1) IN GEARBOX (2).
a.
Apply shortening compound on outside of
shaft (3) inner diameter of housing and out-
side diameter of seal (1).
b.
Place seal (1) on shaft (3) with four holes fac-
ing up. Push by hand to evenly snug the seal
into bore prior to installing the pusher.
c.
Loosen three nuts (4) and install pusher (5) on
gearbox (2). Aline holes with studs (6).
CAUTION
Ensure hub (7) is evenly seated on seal
(1), to prevent damage to gearbox (2).
d.
Secure pusher (5) with three nuts (4). Slowly
turn handle clockwise until hub (7) is evenly
seated on seal (1).
e.
If hub (7) is evenly seated on seal (1), contin-
ue to turn handle slowly clockwise. When
handle cannot be turned any further, seal is
fully seated. Loosen three nuts (4) and re-
move pusher (5).
4. APPLY SEALER ON OUTSIDE EDGE OF NEW
DUST SEAL (8).
5. PLACE SEAL (8) ON SHAFT (9). PLACE INSTAL-
LING TOOL (10) ON SEAL (8) AND TAP INSTALLING
TOOL (10) UNTIL SEAL (8) IS SEATED.
Go on to Sheet 7
Change 6
7-2.4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals