 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
GAS TURBINE POWER UNIT REPLACEMENT (Sheet 23 of 30)
CAUTION
Do not adjust turnbuckle rod bearing
assembly (1). Alignment of vanes with
turbine gearbox housing assembly is
preset at the factory and must not be
disturbed. Damage to parts may result.
Install bolt (2) in turnbuckle rod bearing as-
u.
sembly (1) and connect to turbine gearbox
housing spur gearshaft (3). Tighten bolt (2)
securely.
Remove rigging pin (4).
v.
w. Tighten self-locking nut (5).
Rotate adapter and shaft assembly (6) from
x.
rear of regenerator (7) and check for rubs or
binding. No rubs or binding is permitted dur-
ing rotation check.
NOTE
If a rub is detected, repeat Installation
steps 12.a through x. If this is the third
attempt to eliminate rubbing, assemble
rear engine module with original parts and
replace.
If no rubs are detected, go to next step.
y.
Rotate remote control lever (8) up and down
to check for binding. No excessive binding is
permitted.
Go on to Sheet 24
6-84
Change 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals