REMOVE THREADED STOP

TM 9-2835-255-34

ADAPTER AND SHAFT ASSEMBLY REPAIR (Sheet 4 of 8)

REMOVE THREADED STOP (1). KEY-

LOCK WASHER (2), SPLINED GEAR (3),

RETAINING NUT (4) AND METAL SEAL

RING ASSEMBLY (5) FROM SPLINED

ADAPTER (6).

a. Straighten edge of keylock washer (2).

b. Using socket wrench (7), turn counter-

clockwise to remove threaded stop (1).

Remove keylock washer (2) and discard.

NOTE

Splined gear (3) and splined adapter (6) should be

installed in same position they were removed.

Look for matchmarks (8) on splined gear

(3) and splined adapter (6). If not there use

marker to place matctmmaks there.

d. Install puller (9) and remove splined gear

(3).

e. Remove retaining nut (4) and discard.

f. Remove metal seal ring assembly (5) from

splined adapter (6) and discard.

g. Remove splined adapter (6) from fixture

(10).

Go on to Sheet 5

6-40 Change 4