 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 12 BEARING AND SPLINED COUPLING REPLACEMENT (Sheet 3 of 7)
2. REMOVE NUT (1) AND KEY WASHER (2). RE-
MOVE BEARING AND COUPLING PACKAGE (3).
a.
Uncrimp key washer (2). Using wrench (4),
remove nut (1) and key washer (2).
b.
Using puller (5), remove bearing and coupling
package (3).
NOTE
The bevel gearshaft is located up inside
the intermediate housing where the No. 12
bearing and splined coupling was re-
moved from. To inspect, shine lignt direct-
ly up into the No. 12 bearing and splined
coupling bore. If any of the conditions
described below exist, the forward engine
module is not repairable at DS level of
maintenance. Reassemble forward engine
module with original hardware and re-
place forward engine module (Page
3. USING A FLASHLIGHT INSPECT BEVEL GEAR-
SHAFT FOR SPLINE DAMAGE, SHEARED GEAR-
SHAFT OR EXCESSIVE SPLINE WEAR.
LE5523
Go on to Sheet 4
5-126
Change 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals