LOWER LOW PRESSURE COMPRESSOR ASSEMBLY

TM 9-2835-255-34

NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL)

(Sheet 44 of 49)

CAUTION

Do not rock or bang low pressure com-

pressor assembly (1) during installation.

Damage to the carbon elements of the

intershaft seal in the intermediate housing

(2) will occur.

29. CAREFULLY LOWER LOW PRESSURE COM-

PRESSOR ASSEMBLY (1) ONTO INTERMEDIATE

HOUSING (2).

NOTE

If low pressure compressor housing (1)

does not mate with intermediate housing

(2), slowly raise and turn low pressure

compressor assembly (1) slightly until

mating is achieved. If mating is still not

achieved, raise compressor assembly (1)

and check No. 2 bearing housing tang

alignment with split line on compressor

case. Realign if necessary.

NOTE

Make sure bleed valve rod (3) is posi-

tioned up.

LE5590

Go on to Sheet 45

5-118 Change 6