Assembly-continued - TM-9-2815-224-34-P0402

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

15-3. GOVERNOR REPAIR (CONT).

(6) Mount governor housing (2) in vise with soft

jaws.

(7) Place control link operating lever (8) inside

governor housing (2).

(8) Insert washer (10) on each side of lever (8).

(9) Install operating lever shaft (11 ) with slot up.

(lo) Install locking clip (12), lockwasher (13), and

screw (14).

(11)

Install gap adjusting screw (15) and jamnut (16) into operating lever (17).

Tighten jamnut. (16) so length of gap adjusting screw (15) is same as noted at disassembly.

(12)

(13)

Press pin (18) into operating lever (17).

Press upper bearing (19) with bearings (20) facing up onto operating shaft.

(14)

Press operating lever (17) and bearing (19) on operating shaft (21) until flush with top of shaft.

(15)

15-10