 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 .
TM 9-2815-224-34&P
Engine Governor Maintenance Instructions (Cont)
(16) Install shaft (21 ) and position lever (17) so gap
adjusting screw (15) contacts low speed limiting
screw (22).
NOTE
Flat on shaft goes on flat in fork.
(17) Place shaft (21 ) into spacer (23) and position
operating fork (24) with finished cam surfaces
of fork fingers facing rear of governor
housing.
(18) Place tool between housing (2) and operating
fork (24) and press shaft (21) until spacer (23)
does not move up or down.
(19) Seat upper bearing (19).
(20) Install upper bearing retaining screw (25),
lockwasher (26), and washer (27).
15-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals