Section III. WATER PUMP DRIVE GEAR ASSEMBLY

TM 9-2815-224-34&P

Blower and Water Pump Drives Maintenance Instructions (Cont)

10-40 BLOWER DRIVE SEAL RING REMOVAL/INSTALLATION (CONT).

(3) Install blower drive seal ring (1) on blower drive (3)

with cement coated cut end (2) on top.

(4) Slide other cut end of blower drive seal ring (1) up to

mate with cement coated end.

(5) Hold joined ends of blower drive seal ring (1)

together for 30 seconds.

(6) Position seal ring clamp (4) between raised edges of

blower drive seal ring (1).

(7) Tighten seal ring clamp (4).

c. Follow-on Maintenance.

(1) Start engine (TM 9-2320-279-10).

(2) Let engine idle for three or four minutes. Then check around blower drive seal ring for oil leaks.

(3) Install engine cover (TM 9-2320-279-20).

END OF TASK

Section Ill.

W A T E R PUMP DRIVE GEAR ASSEMBLY

10-5. WATER PUMP DRIVE GEAR REMOVAL/INSTALLATION.

This task covers:

a. Removal

c. Follow-on Maintenance

b. Installation

INITIAL SETUP

Equipment Condition

Models

All

TM or Para

Condition Description

Test Equipment

Front balance cover

removed.

None

Special Environmental Conditions

Special Tools

None

General Safety Instructions

Supplies

None

Level of Maintenance

Personnel Required

Direct Support

MOS 63W, Wheel vehicle repairer

References

None