BLOWER DRIVE SEAL RING REMOVAL/INSTALLATION.

TM 9-2815-224-34&P

Blower and Water Pump Drives Maintenance Instructions (Cont)

10-4. BLOWER DRIVE SEAL RING REMOVAL/INSTALLATION.

This task covers:

c. Follow-on Maintenance

a. Removal

b. Installation

INITIAL SETUP

References

Models

None

All

Equipment Condition

Test Equipment

None

TM or Para

Condition Description

Special Tools

TM 9-2320-279-20 Engine cover removed.

None

Special Environmental Conditions

Supplies

None

Cement, general purpose, synthetic base,

General Safety Instructions

None

Personnel Required

Level of Maintenance

MOS 63W, Wheel vehicle repairer

Direct Support

a. Removal.

(1) Loosen seal ring clamp (1) and slide clamp off blower drive seal ring (2)

(2) Cut and remove blower drive seal ring (2).

b. Installation.

NOTE

Make sure cut ends of blower drive seal ring are straight and

clean.

(1) Cut blower drive seal ring (1) straight across.

WARNING

Use general purpose cement lightly and avoid contact with skin.

Cement will burn on contact.

(2) Apply general purpose cement to one end (2) of cut blower drive seal ring (1).