|
|
(E) Install 3/8-inch plain washer, 3/8-
b. Connect Fuel Hoses. The three fuel hoses
inch lock washer, and 3/8- inch plain
are-similar in appearance, however two of them
nut to secure inner clamp. (F) Install
are 29 inches long, and the third one is 25-
fuel injection tube outer clamp over
inches long. The shorter hose must be installed
fuel injection tubes. (G) Install two
on the fuel injection pump fuel supply pump-to-
1/4 x 1-3/8 cap screws, 1/4-inch plain
filter inlet elbow. Connect fuel hoses as follows.
washers, and 1/4-inch self locking nuts
to secure fuel injection tube inner and
(1) Figure 511. (A) Connect end of 25-inch
outer clamps together. (H) Move fuel
long fuel supply pump-to-fuel filter
inlet hose to 90 degree elbow at fuel
injection tube dust caps down over tube
filter inlet. (B) Connect other end of
nuts and fuel injection pump ports.
hose to 90 degree elbow at fuel supply
pump outlet. (C) Connect one end of
injector supply-to-fuel filter outlet hose
SEMBLY AND FUEL HOSES
to 90 degree elbow at fuel filter outlet.
a. Install Fuel Filter Assembly. Use two
(D) Connect other end of hose to 45
degree elbow in fuel injection pump
new fuel filter elements, gaskets, and preformed
packings when installing filter elements and
hydraulic head. (E) Connect one end of
cases. Refer to figures 228 and 229 and reverse
fuel return-to-fuel filter inlet hose to
the sequence of illustrations and instructions to
45 degree elbow in overflow return tee.
install the fuel filter assembly.
(F) Connect other end of hose to 90
324
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |