|
|
![]() (2) Figure 287. (A) Install 3/8-16 puller
screws o f mechanical puller kit -
8708724 into the puller screw holes.
Insert small end plug - 10899178 in
threaded end of crankshaft and run
puller jack screw against plug. (B) Pull
crankshaft damper and pulley assembly
from crankshaft.
DAPTER
a . General. To drive the engine tachometer
mounted on the vehicle control panel, a tacho-
meter drive adapter is mounted on the timing
gear cover and is driven by the camshaft.
b. Removal. Figure 288. (A) Remove tacho-
meter drive adapter and drive shaft from tacho-
meter take-off adapter. (B) Remove tachometer
take-off adapter and adapter gasket.
CRANKSHAFT BOLT LOCK PLATE.
PER AND PULLEY ASSEMBLY USING
MECHANICAL PULLER KIT - 8708724
AND PLUG - 10899178.
TACHOMETER ADAPTER.
175
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |