 |
|||
|
|
|||
|
Page Title:
FUEL INJECTOR NOZZLE AND HOLDER ASSEMBLIES |
|
||
| ||||||||||
|
|
 (4) Refer to figure 146 and disconnect sole-
b. Installation. Refer to figures 143 through
noid valves from flame heater fuel pump
147 and reverse the sequence of illustrations
and fuel filter bracket.
and instructions to install the flame heater sole-
noid valves.
(5) Refer to figure 146 and remove solenoid
ASSEMBLIES
a. General. All injector nozzle and holder
assemblies are replaced and repaired in the
same manner.
b. Removal. Remove fuel injector nozzle and
holder assemblies as follows.
(1) Figure 148. (A) Disconnect fuel return-
to-fuel injection pump overflow valve
tube from 1/4-inch tube tee in nozzle
and holder assembly. (B) Disconnect
the fuel injector nozzle fuel return
tube from the 1/4- inch tube tee in fuel
injector nozzle and holder assembly.
Remove tube. (C) Disconnect fuel in-
jector tube from fuel injector nozzle
and holder assembly, (D) Remove two
5/16 x 2-1/2 cap screws and 5/16-inch
lock washers securing fuel injector
nozzle hold- down clamp and fuel injector
nozzle and holder assembly to cylinder
head.
NECTING FUEL INJECTOR NOZZLE
AND HOLDER FUEL RETURN TUBE,
FUEL INJECTION TUBE , AND
HOLD-DOWN CLAMPS.
107
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals