 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 82. FLAME HEATER SOLENOID VALVES
a. Removal. Remove flame heater solenoid
valves as follows.
(1) Figure 143. (A) Disconnect harness
ground wire by removing No. 10 plain
nut and No. 10 lock washer from No.
10 x 1-3/4 machine screw. (B) Dis-
connect flame heater harness from
receptacle connector at rear of flame
heater fuel pump. (C) Disconnect flame
heater harness from fuel return sole-
noid valve and fuel inlet solenoid valve.
(D) Disconnect 1/8-inch tube nut from
fuel pump outlet union. (E) Disconnect
1/4-inch tube nut on fuel return-to-fuel
solenoid valve tube from 90 degree el-
bow in solenoid valve.
NECTING FLAME HEATER SOLENOID
VALVE TUBES AND HARNESS.
(2) Refer to figure 144 and remove flame
heater fuel pump and fuel filter bracket.
(3) Figure 145. (A) Disconnect 1/4-inch
tube nut on fuel filter-to-fuel inlet sole-
noid valve tube from 90 degree elbow
in solenoid valve. (B) Disconnect 1/4-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals