 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (2) Figure 110. (A) Remove thermostat
b. Installation. Refer to figures 109 through
housing assembly with thermostat in-
111 and reverse the sequence of illustrations
stalled. (B) Remove and discard intake
and instructions to install a new thermostat
manifold-to-thermostat housing gasket.
and/or seal. Install a new intake manifold-to-
thermostat housing gasket.
a. Removal. Remove water pump assembly
as follows.
(1) Figure 112. (A) Remove four 5/16 x 3/4
cap screws and 5/16- inch lock washers
securing engine fan to water pump
pulley. (B) Remove engine fan from
pulley.
THERMOSTAT HOUSING AND
THERMOSTAT.
(3) Figure 111. (A) Remove thermostat
from thermostat housing assembly. (B)
Inspect thermostat seal. When defects
are noted, replace seal.
ENGINE FAN.
(2) Figure 113. (A) Remove 3/8 x 7/8 cap
screws, 3/8- inch lock washer, and
special flanged washer securing gen-
erator adjusting strap to generator as-
sembly. (B) Push generator assembly
toward engine and remove the two en-
gine fan and generator drive belts from
generator pulley, water pump pulley,
(C) Remove 3/8- inch plain nut and 3/8-
inch lock washer securing generator
adjusting strap to water pump. Remove
THERMOSTAT AND THERMOSTAT
adjusting strap.
SEAL.
92
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals