 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 76. COOLANT THERMOSTAT AND SEAL
a. Removal. Remove coolant thermostat and
seal as follows.
(1) Figure 109. (A) Remove two 3/8 x 3-5/8
cap screws and 3/8- inch plain washers
securing thermostat housing assembly
to intake manifold. (B) Loosen two 2-
inch clamps securing thermostat hous-
ing-to- water pump hose.
OIL PRESSURE SENDING UNIT AND/
OR CYLINDER BLOCK WATER
JACKET DRAIN COCK.
a. Removal. Refer to figure 108 and remove
water temperature sending unit.
b. Installation. Refer to figure 108 to install
the-water temperature sending unit.
WATER TEMPERATURE SENDING
INSTALLED VIEW.
UNIT.
91
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals