APPENDIX B. DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST

APPENDIX B

D I R E C T SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE

R E P A I R PARTS AND SPECIAL TOOLS LIST

Section I INTRODUCTION

1. Scope

Federal Stock numbers in ascending numerical

sequence, cross-referenced to the illustration

This appendix lists repair parts and special

figure number and item number.

tools required for the performance of direct

3. Explanation of columns

support, general support and depot maintenance

of Engine, with Container: Turbosupercharged,

The following provides an explanation of

D i e s e l , Fuel Injection, 90-degree "V" Type, Air

columns in the tabular lists in Sections II and

Cooled, 12 Cylinder Assembly, Continental

III:

Models AVDS-1790-2M (2815-856-4996),

a. Source, Maintenance, and Recoverability

AVDS-1790-2A and AVDS-1790-2AM (2815-

856.9005). Part number and Federal stock

Codes (SMR), Column 1.

(1) Source code, indicates the selection

number indexes are also included.

status and source for the listed item. Source

2. General

c o d e s used are:

This Repair Parts and Special Tools List is

Code

Explanation

d i v i d e d into the following sections:

a. Repair Parts - Section II. A list of engine

Repair parts which are not procured or stocked as

"M"

parts, in Government Group number sequence

separate supply items but are to be manufactured

and keyed to figure and number, showing

i n indicated maintenance levels. The lowest

maintenance level authorized to manufacture the

authorized repair parts for the performance of

item will be entered in the second digit position of

maintenance at the direct support, general

the source code.

support and depot levels.

Repair parts which are high mortality parts,

"P"

b. Special Tools and Test Equipment -

stocked in or supplied from the GSA/DSA or

Section III. A list of special tools and test

Army supply system, and authorized for use as

indicated maintenance categories

equipment authorized for the performance of

"P2"

Repair parts which are procured and stocked for

maintenance at the direct support, general

insurance purposes because the combat or military

support and depot levels is given in ascending

e s s e n t i a l i t y of the end item dictates that a

F e d e r a l stock number sequence, cross-referenced

minimum quantity be available in the supply

to illustration figure number and item number.

system.

Applied to repair parts which are not procured or

"X1"

Quantities shown in the Special Tools List are

s t o c k e d , the requirement for which will be

those required for each support unit charged

supplied by use of the next higher procured or

with the responsibility of supporting this

stocked component or assembly.

equipment.

Applied to repair parts which are not stocked. The

"X2"

c. General Use Standardized Parts - Section

indicated maintenance category requiring such

repair parts will attempt to obtain these parts by

I V . A list of all standard hardware and parts in

c a n n i b a l i z a t i o n ; if not obtainable by can-

alphabetical part name order with the hardware

such repair parts will be

nibalization,

listed in ascending sizes.

r e q u i e i t i o n e d with supporting justification

d. Part Number and Federal Stock Number

through normal supply channels.

I n d e x e s - Section V. A list of part numbers and

B-1