Figure 5-38. Removing or installing fuel/ water separator filter

Remove

1. Remove cotter pin, slotted nut (A), flat washer, and

bolt Separate adjustable control rod from cross shaft

lever.

2. Remove two cap screws (B) and lock washers at-

taching primary fuel filter mounting bracket to cylinder

No. 1 R. Remove mounting bracket.

3. Remove cap screw (C) and lock washers attaching

camshaft end plate to cylinder No. 1R.

4. Remove two assembled washer bolts (D) attaching

cross shaft bracket. Remove bracket, end plate with

tachometer drive adapter, and throttle linkage cross

shaft as a unit. Separate cross shaft from camshaft end

plate. Remove and discard camshaft end plate gasket.

Install

Remove

1. Install new camshaft end plate gasket. Install throttle

1. Disconnect fuel outlet hose (A) from elbow in

linkage cross shaft in camshaft end plate. Position cross

fuel / water separator filter and remove hose.

shaft bracket, end plate with tachometer drive adapter,

2. Disconnect and remove fuel inlet hose (B).

and cross shaft as a unit on right front shroud. Install

3. Remove fuel inlet and outlet elbows and drain tube

two assembled washer bolts ( D) securing cross shaft

elbow (C) from filter.

bracket.

4. Disconnect and remove fuel/ water separator filter

2. Install cap screw (C) and lock washer securing

fuel drain tube (D).

camshaft end plate to cylinder No. 1 R.

5. Remove lower two cap screws (E), lock washers, and

3. Position primary fuel filter mounting bracket on

plain washers.

cylinder No. 1 R and install two cap screws (B) and lock

6. Remove upper two cap screws (F), lock washers, and

washers securing bracket to cylinder.

plain washers attaching fuel / water separator filter to

4. Position cross shaft lever and adjustable control rod

mounting bracket. Remove filter.

and install bolt, flat washer, slotted nut (A) and cotter

Install

pin.

1. Position fuel/ water separator filter on mounting

bracket and install upper two cap screws (F), lock

Figure 5-39. Removing or installing primary

washers, and plain washers securing filter to bracket.

fuel filter bracket, throttle linkage cross

2. Install lower two cap screws (E), lock washers, and

shaft, and camshaft end plate.

plain washers.

3. Install fuel inlet and outlet elbows and drain tube

elbow (C) in filter.

4. Position fuel/ water separator filter fuel drain tube

(D) under filter and connect tube to filter.

5. Connect fuel inlet hose (B) to filter.

6. Connect fuel outlet hose (A) to elbow in filter.

Figure 5-38. Removing or installing

fuel/ water separator filter.

5-21