Figure 5-23. Removing or installing right manifold heater fuel return tube.

Remove

1. Disconnect turbosupercbarger oil inlet hose (A) from

bulkhead adapter elbow and remove hose.

2. Remove two machine screws (B) attaching right

transmission shroud and remove shroud.

Note. Left turbosupercharger oil inlet hose

a n d transmission shroud are removed or in-

stalled in the same manner.

Install

1. Position right transmission shroud on rear of engine

and install two machine screws (B) securing shroud.

2. Connect oil inlet hose (A) to bulkhead adapter elbow.

5-6. Manifold Heater Tubes, Solenoids,

and Filter, Cylinder Head Oil

Drain Lines, and Intake Manifold

Assemblies

Figure 5-22. Removing or installing right

turbosupercharger oil inlet hose and

Refer to Table 5-3 for illustrations and

transmission shroud.

disassembly instructions. Figure references are

listed in the table.

Table 5-3. Manifold Heater Tubes, Solenoids and Filter, Cylinder

Head Oil Drain Lines, and Intake Manifold Assembly-

Figure Reference

Component

5-23 through 5-27

Manifold Heater Tubes, Hoses, Fuel Check Valve, Fuel

Filter, Bracket. and Solenoid Valves

5-28 through 5-32

Cylinder Head Oil Drain Tubes

5-33

Intake Manifold, Manifold Heater, and Turbosupercharger

Air Outlet Elbow

Remove

1. Remove machine screw (A) attaching right manifold

beater fuel return tube clamp to right rear shroud.

2. Disconnect fuel return tube (B) from heater and tube

tee. Remove tube.

Note. Left manifold heater fuel return tube is

removed or installed in the same manner.

Install

1. Position right manifold heater fuel return tube (B) on

right rear shroud and connect to heater and tube tee.

2. Install machine screw (A) securing fuel return tube

clamp to right rear shroud.

Figure 5-23. Removing or installing right

manifold heater fuel return tube.

5-13