Section VI. REPLACEMENT OF ENGINE OIL PAN

Disassemble

Assemble

1. Install intake manifold tubes for cylinders 1L, 2L, 5L,

1. Remove six nuts (A) and flat washers attaching intake

manifold elbow to intake manifold. Remove elbow and

and 6L following instructions accompanying figure 4-

110.

heater tube as a unit. Remove and discard gasket.

2. Install new gaskets on studs on intake manifold for

2. Remove four nuts (B) attaching intake manifold tubes

cylinders 3L and 4L intake manifold tubes. Position

3 L and 4L to intake manifold and remove tubes,

Remove and discard gaskets.

tubes on manifold and install four nuts (B) securing

each tube to manifold.

3. Remove intake manifold tubes for cylinders 1L, 2L,

3. Install new intake manifold elbow gasket on manifold

5L, and 6L following instructions accompanying figure

studs. Position intake manifold elbow and heater tube

4-110.

as a unit on manifold. Install six nuts (A) and flat

washers securing elbow to manifold.

Figure

4-118.

Disassembling

assembling

intake

manifold

assembly.

Section

VI.

REPLACEMENT

ENGINE

OIL

PAN

4-12. General

removal and installation of the oil pan. Figure

This

section covers the replacement of the

engine

o i l p a n . Refer

Table

4-5

for

references are listed under appropriate headings

instructions

covering

the

illustrations

in the table.

and

Table 4-5. Engine Oil Pan

4-58