Figure 4-29. Removing or installing transmission oil cooler end shroud and inner shroud plate.

2. Remove long bolt (B) and lock washer.

3. Separate oil drain tube (C) from turbosupercharger.

Remove and discard gasket.

Connect

1. Position new gasket between turbosupercharger and

oil drain tube (C).

2. Install long bolt (B) and lock washer.

3. Install short cap screw (A) and lock washer.

Figure

4-30.

Disconnecting

connecting

turbosupercharger oil drain tube at

Remove

1. Remove two bolts (A) attaching the transmission oil

cooler end shroud.

2. Remove end shroud and inner shroud plate (B).

Install

1. Position inner shroud plate and transmission oil cooler

end shroud (B) on engine.

2. Install two bolts (A) securing end shroud.

Figure 4-29. Removing or installing trans-

mission oil cooler end shroud and inner

shroud plate.

Disconnect

1. Loosen hose clamps (A) on air outlet elbow hose.

2. Remove six self-locking nuts (B) attaching elbow to

t u r b o s u p e r c h a r g e r compressor housing and remove

elbow.

3. Remove and discard elbow gasket (C).

4. Remove outer self-locking nut (D) and flat washer

attaching turbosupercharger to mounting base.

5. Loosen hose clamps (E) and remove oil drain tube.

Connect

1. Position oil drain tube and tighten hose clamps (E).

2 . Install outer self-locking nut (D) and flat washer

securing turbosupercharger to mounting base.

3. Position new elbow gasket (C) on studs.

4 . P o s i t i o n a i r o u t l e t e l b o w o n turbosupercharger

compressor housing and install six self-locking nuts (B)

securing elbow to housing.

5. Tighten hose clamps (A) on air outlet elbow.

Disconnect

Figure

4-31.

Disconnecting

connecting

1. Remove short cap screw (A) and lock washer.

turbosupercharger

air

outlet

elbow.

4-16