Section XIV. TESTS AND ADJUSTMENTS

Install spacer(s) (A) and retainer (B) on each of six

Using a hoist in sling 4910-572-8614 (8356184),

drive studs (C), after removing lifting eye 4910-

(A) remove transmission (B) from stand 4910-499-

5 7 3 - 3 8 0 1 (10865773) (D) and strap 4910-572-

4196 after four 5/8-11 bolts are removed.

8608 (8356175) (E).

NOTE

Spacers selected to meet the 1.566

dimension, plus retainer thickness of

approximately 0.016 inch, will meet the

1.582 dimension in figure 5-137.

S e c t i o n XIV. TESTS AND ADJUSTMENTS

5-59. General

(1) Tachometer to indicate transmission input

speed.

a. The tests in this section will determine if the

NOTE

functional operation of the transmission is

To convert engine speed readings, for the

satisfactory. The tests may be made after overhaul

M 1 1 3 A 1 f a m i l y o f v e h i c l e s , t o trans-

( r e b u i l d ) or to determine the condition of the

mission i n p u t s p e e d , m u l t i p l y engine

transmission at any time. The tests may be made

speed by 1.286.

while the assembly is installed in the vehicle or on a

(2) Gages for reading oil pressures. Refer to

properly equipped test stand.

table 3-1 for pressure gage kit 4910-572-8612.

b. These tests will determine whether or not the

(3) Tachometer to indicate transmission

clutches, gearing, a n d hydraulic system are

output speed (drive line disconnected at output).

performing properly.

(4) A bulb-type temperature indicator which

C . Adjustments of the transmission assembly

will read to 400F., with fittings to install bulb into

components and control linkages must be correct

oil line carrying oil to cooler.

when tests are performed. When tests are made in

the vehicle, the engine must be properly tuned and

(5) A spring to hold engine throttle linkage in

closed position while accelerator linkage is

performing efficiently. Refer to the engine technical

disconnected from engine.

manual for engine tests and adjustments. Refer to

b. Transmission Installed on Test Stand. T h e

paragraphs 5-62 and 5-63 for transmission tests

following equipment is required for testing the

and adjustments.

transmission on a test stand.

5-60. Test Equipment

(1) The equipment listed in a (1) through (4)

a. `Transmission Installed in Vehicle. T h e

above is required for testing the transmission out of

following equipment is required when testing the

the vehicle. In addition, a test stand and other

transmission assembly in the vehicle.

equipment is needed.

5-59