Lock output flange bolt

Lock output flange bolt (A) by bending lock tab

Install large jumper tube (A) and seal rings (B).

(B) against a flat side of bolt head. Stake edge of

Install a retaining ring (C) in each of six small

washer into hole (C) in flange (D).

jum per tube holes.

NOTE

There are no grooves; seat retaining rings

against jumper tubes.

Install six small jumper tubes (A) with seal rings

(B) at six places (C).

NOTE

Install rear pump check ball (A) (nylon) in cavity

Do not interchange seal rings on ends of

(B) in transmission housing.

tubes since there is a difference in size.