 |
|||
|
|
|||
|
Page Title:
Converter Stator and Cam Assembly |
|
||
| ||||||||||
|
|
 NOTE
(4) Place converter pump bearing retainer
To make installation of lockup clutch
(22) over ball bearing, and aline holes (fig. 5-56).
piston assembly easier, put a pencil mark in
(5) Install eight bolts (20) through four new
line with pin nearest orifice in piston (when
tab locks (21). Tighten bolts to 9 to 11 pound-feet
balance marks are alined as in figure 5-58).
(6) Bend pointed corners of lock tabs up
Then, when piston assembly is being in-
stalled, use pencil mark as a guide to
against flat sides of bolt heads to lock bolts.
l o c a t i o n of pin beneath orifice. One
(7) Replace converter pump flange bolts (30),
as necessary, and make sure weights (31) (if any)
recessed hole in piston is concentric with
are in place if pump bolts have been removed.
orifice. Rotate piston slightly, if necessary,
(8) Install hook-type seal ring (25) on pump
during installation to insure that piston
hub (24).
engages pins. To make certain that piston
is properly seated, measure distance from
pump cover mounting surface to piston;
this distance should be approximately 11/2
inches.
CAUTION
Lockup clutch will not release if piston is
not engaged with pins.
(5) Install snap ring (9) on converter pump
cover (4) hub.
53).
(1) Position converter stator and cam
assembly (fig. 5-59) with largest inside diameter
up. Install 10 springs in cam pockets. Ends of
springs must be toward center of stator and cam
assembly and in deep end of cam pockets. Relative
position of spring and roller is shown.
(2) Install holder assembly 4910-572-8588
Install 10 rollers in cam pockets. Lubricate rollers
and springs with transmission oil.
(3) Install freewheel roller race (35), coun-
terbored side facing away from stator and cam
assembly (16). into stator and cam assembly.
Rotate freewheel roller race in a clockwise direction
while installing, and seat on holder assembly.
(4) Hold freewheel roller race in place, and
turn stator and cam assembly over (fig. 5-61).
R e m o v e holder assembly 4910-572-8688 by
pulling on chain provided.
(5) Seat freewheel roller race (35 ) on needle
bearing assembly (17). Position stator and cam
assembly so freewheel roller race is upward until
read y for installation.
(1) Position new converter pump hub gasket
(26) on mounting face of converter pump (29).
(2) Install ball bearing (23) in converter pump
hub (24).
(3) Install pump hub in converter pump bore,
and aline holes.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals