 |
|||
|
|
|||
|
Page Title:
Install converter output shaft and bearing |
|
||
| ||||||||||
|
|
 TM 9-2520-249-34& P
63 Install converter output shaft and bearing (1)
into high-range clutch pack (2).
65 Lay the converter housing on its side. Install
two 10-32 x 6-inch headless guide bolts (1) onto
pitot tube (2) and insert the guide bolts into
housing (3) as shown. At rear of housing, install
converter output shaft and clutch pack (4),
engaging the pitot tube within the lip of collector
ring (5).
NOTE
Inlet part of pitot tube must be
outward and facing clockwise.
Carefully seat the shaft and clutch
pack assembly while pushing the
64 Temporarily install intermediate-low sun gear
pitot guide bolts through the
(1), splined washer (2). and snapring (3) onto
housing.
converter output shaft (4).
NOTE
These
parts
will
maintain
proper
positioning of the output shaft and clutch
pack within the converter housing during
subsequent assembly.
8-25
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals