Section X. REPAIR (MODEL P-136-C)

TM 9-2520-246-34

Section X. REPAIR (MODEL P-136-C)

5-26. Disassembly and Assembly.

a. Drain Plug and Shift Lever.

(1) Remove the drain plug (fig. 5-29) and drain

the power takeoff.

(2) Remove the two cotter pins, nut, and washers

securing the shift lever to the carrier. (See fig. 5-29.)

Remove the shift lever from the carrier.

Figure 5-30. Removal of Pump, Shifter Shaft Retainer,

Spring, and Ball.

Figure 5-29. Drain Plug, Two Cotter Pins, Nut,

Washers, and Shifter Shaft.

Figure 5-31. Removal of Shifter Shaft.

NOTE

c. Output Shaft Rear Bearing Retainer and Oil

During assembly, use new cotter pins.

Seal.

b. Pump and Shifter Shaft.

(1) Remove the four capscrews and lockwashers

securing the retainer to the carrier. (See fig. 5-32.)

(1) Remove the four capscrews and lockwashers

securing the pump to the carrier. (See fig. 5-30.)

(2) Place the retainer in a vise, and drive the oil

Remove the pump and gasket. Discard the gasket.

seal from the retainer using a suitable punch and

hammer. See figure 5-32 for location and positioning

NOTE

of the oil seal.

Assemble using a new gasket.

NOTE

(2) Remove the shifter fork setscrew and remove

Upon assembly, use a new oil seal.

the shifter shaft. (See fig. 5-31.)

5-18