Rear Output Shaft and Sliding Clutch Sleeve.

TM 9-2520-246-34

(2) Using a suitable tool, drive the shifter shaft

oil seal and boot from the housing. (See fig. 5-25.)

NOTE

When installing the shifter shaft boot and

oil seal, press the oil seal in part way and

fit the boot around the seal, then continue

to press the seal into position.

Figure 5-21. Removal of Rear Output Shaft

Housing Shifter Shaft Retainer, Ball,

and Spring.

c. Rear Output Shaft and Sliding Clutch Sleeve.

(1) Using a pair of snapring pliers, remove the

output shaft snapring securing the shaft to the

bearing. (See fig. 5-23.)

Figure 5-23. Removal of Output Shaft Snapring.

Figure 5-22. Removal of Shifter Shaft and

Shifter Shaft Fork.

(2) Place the rear output shaft housing in a vise.

Using a soft drift pin, drive the rear output shaft from

the housing and remove the sliding clutch sleeve. (See

d. Rear Output Shaft Bearing and Shifter Shaft

Boot and Oil Seal.

(1) Using a pair of snapring pliers, remove the

bottom and top snaprings securing the rear output

shaft bearing in the housing and remove the bearing.

Figure 5-24. Removal of Rear Output Shaft and

Sliding Clutch Sleeve.

5-13