Section XVI. FSG 58, COMMUNICATION, DETECTION, AND COHERENT <a href="http://armyintelligence.tpub.com/is11325/Radiation-15.htm">RADIATION</a> EQUIPMENT, AND FSG 59, ELECTRICAL AND ELECTRONIC EQUIPMENT COMPONENTS

TM 746-10

5-1). Mark per paragraph 3-5.

5-103. Component Items (70 Pounds or Less)

5-105. Valve Assemblies (More than 70 Pounds)

a. Coat exposed machined surfaces of pin

assemblies, slip clutches, panel assemblies, spider

Preserve and pack valves per paragraph 5-92.

clutches, roller connectors, and female eye assemblies

with P-10. Wrap preserved areas with greaseproof barrier

5-106. Straight Shafts (More than 70 Pounds)

material and secure in place with tape.

b. Cushion items with cellulosic cushioning material

Preserve and pack shafts per paragraph 5-24.

and individually pack in weather-resistant fiberboard

boxes. Close and seal box with tape (fig 5-1). Mark per

5-107. Rear Wheel and Suspension Installations

paragraph 3-5.

a. Coat interior surfaces with operating fluid and

5-104. Hydraulic Motors

drain.

b. Coat exterior, unpainted, ferrous metal surfaces

a. Coat interior surfaces with operating fluid and

with P-10. Wrap with greaseproof barrier material and

allow to drain.

secure with tape.

b. Coat exterior, unpainted, ferrous metal surfaces

with P-10. Wrap motors with greaseproof barrier material

5-108. End Sections and Truss Assemblies

and secure in place with tape.

c. Cushion items with cellulosic cushioning material

Coat unprotected metal surfaces with P-1.

and individually pack in weather-resistant fiberboard

boxes. Close and seal box with tape (fig

Section XVI. FSG 58, COMMUNICATION, DETECTION, AND COHERENT

RADIATION EQUIPMENT, AND FSG 59, ELECTRICAL AND ELECTRONIC

EQUIPMENT COMPONENTS

5-109. Electronic Components (5 Pounds or Less)

ESDS items shall be preserved

submethod IA-8 and as specified in

Cushion items with cellulosic cushioning material and

section XXIII herein.

individually unit pack method IC-3.

5-110. Relay Boxes (70 Pounds or Less)

CAUTION

Cushion items with cellulosic cushioning and individually

Circuit cards and other electronic

pack in weather-resistant fiberboard boxes. Close and

seal box with tape (fig 5-1).

components that have been identified

Section XVII. FSG 61, ELECTRIC WIRE AND POWER DISTRIBUTION EQUIPMENT

tor assemblies, cooler assemblies, and governors with P-

10. Wrap preserved areas with greaseproof barrier

5-111. Generators, Motors, and Alternators

material and secure in place with tape.

Preserve and pack generators, motors, alternators, starter

b. Cushion all items with cellulosic cushioning

motors, and motor generators per instructions contained in

material and individually unit pack submethod IC-1.

sections II and VI of this chapter.

5-113. Electric and Electronic Components (100

5-112. Electric and Electronic Components (5 Pounds

Pounds or Less)

or Less)

a. Coat exterior, unpainted, ferrous metal surfaces

a. Coat exposed machined surfaces of panel

of accessory cases, alternators, amplifiers, armatures,

assemblies, electrical chassis, contact assemblies, regula-

battery chargers, box assemblies, breakers, cables, coils,

control boxes, control units, doors, electrical rings,

exciters, frame and stators,

tors,

motors,

check

valves,

converters,

relay

subassemblies, rectifier assemblies, voltage regula5-14

5-14