Installation (CONT) - TM-55-8145-203-13-P0061

TM 55-8145-203-13&P

(19) At top and bottom of door, trim the ends of the

seal (1) so they are flush with the inside edge

of the door.

(20) Stretch the rectangular seal (1) around the

right-hand door (2). Make sure the large curved

lip of the seal is on the outside portion of the

door.

(21) Pull the seal (1) away from the bottom edge of

the door (2) allowing access to the inside edge

of the seal.

NOTE

Installation of the carriers must be complete

before polyurethane is allowed to dry.

(22) Starting from about eight inches above the

inside bottom edge of the door, apply a 1/8

OUTSIDE OF DOOR

inch bead of polyurethane sealant (3) (Item 2,

Appendix G) along the middle of the seal

facing the edge of the door. Continue the

application to the other side of the seal and up

the edge for about another eight inches.

(23) Install the seal around the bottom edge of the

door.

(24) Position the appropriate long carrier along the

outside edge of the right-hand door.

(25) Repeat Steps (13) and (14) for the long carrier.

(26) Position the appropriate long carrier along the

inside edge of the right-hand door.

8 INCHES

(27) Repeat Steps (13) and (14) for the long carrier.

(28) Position the appropriate short carrier along the

top edge of the door.

(29) Repeat Steps (13) and (14) for the short carrier.

(30) Position the last short carrier along the bottom

edge of the right-hand door.

(31) Repeat Steps (13) and (14) for the short carrier.

Chahang1 1 5-8.1

C nge e