Installation (CONT) - TM-55-8145-203-13-P0060

TM 55-8145-203-13&P

(11) Starting from about eight inches above the inside

bottom edge of the left door, apply a 1/8 inch bead of

polyurethane sealant (1) (Item 2, Appendix F) along

the seal (2). Continue the application to the end of

the seal.

NOTE

Be sure to use the marks previously made in Step

(3) to orient the carriers prior to installation. The

orientation of the carriers should be the same as

when they were marked.

8 INCHES

(12) Hold the appropriate long carrier (1) in position

against the seal (2).

(13) Drill a 3/16 inch hole for the rivet through the carrier

(1), seal (2), and door at the two end marks on the

carrier.

(14) Install a rivet in each end of the carrie r; then one in

the center. Work from the center towards each end to

install the remaining rivets.

(15) Install the top of the seal over the door, gently

pulling the seal toward the inside door edge. The seal

will extend beyond the inside door edge. This excess

will be trimmed later.

(16) Position the appropriate short carrier along the top

edge of the door.

(17) Repeat Steps (12), (13), and (14) for the short carrier.

(18) Repeat Steps (16) and (17) for the bottom edge of the

door.

5-8.0

Change 1