Installation (CONT) - TM-55-8145-203-13-P0059

TM 55-8145-203-13&P

(2) Position one of the long carriers along the outside

edge of the left-hand door next to the row of

nails. The carrier should not extend beyond either

door end.

(3) Mark each end of the carrier in order to maintain

the same orientation during final installation.

(4) Compare the marks on the carrier (1) to the nail

1/4 INCH MINIMUM

(2) (or rivet) stubs on the edge of the door. If any

of the marks are located too close (within 1/4

inch) to a nail (or rivet), cross that mark out and

make another one further away from the existing

stub. Keeping a minimum distance between the

new drill mark and old nail (or rivet) locations

ensures that the drill bit will not bind.

(5) Position one of the short carriers along the top

edge of the door next to the row of nails.

(6) Repeat Steps (3) and (4) for the short carrier.

(7) Position one of the short carriers along the

bottom edge of the door. Repeat Steps (3) and

(4).

(8) Repeat Steps (2) through (5) for the right-hand

door carriers.

(9) When all the carriers have been marked and

compared to existing nail (or rivet) locations,

grind the nails (1) (or rivets) further so the shafts

of the nails (or rivets) are flush with the edge of

the door.

(10) Stretch the C-shaped seal (1) over the left-hand

door's outside edge (2). Make sure seal is

orientated so the large, curved lip of the seal is on

the outside portion of the door.

NOTE

Installation of the carriers must be completed

before polyurethane sealant is allowed to dry.

OUTSIDE DOOR

Change e 1 5-5-.9

Chang 1